Contemporary Research ICC1 Produkthandbuch - Seite 7

Blättern Sie online oder laden Sie pdf Produkthandbuch für Controller Contemporary Research ICC1 herunter. Contemporary Research ICC1 20 Seiten. Smart tv controller, rear mount

Seite drucken

On-Screen Setup Menus

The remaining installation steps use the IR remote and the TV's built-in character generator.

1. Touch Menu, then 999, then Enter.

2. The text CR MENU> should appear on the screen.

3. Key in one of the commands shown below, then press Enter to activate.

4. Note that, in Menu mode, the Channel Down key acts as a backspace/delete key and Channel Up

can act as an Enter.

Command

All

45678

45679

65478

65479

65487

65482

ICC2

65480

65481

65483

Contemporary Research Corporation

Function

The following commands are used for all units

Display firmware version

Display the unit's Device #. At this point, you can use the Channel Down key as a

Delete key, enter a new device # with the remote's numeric keypad, then hit Enter

to save the new number.

Reset unit, similar to disconnecting power then restarting.

Disable smart port communication. After about 5 seconds the TV will drop

communication with the TV controller and revert to stand alone TV mode. At this

point, the installer can switch to the TV Mode on the remote control, and then adjust

the TV setup parameters. To re-enable smart port, press Record on IC-RC.

Initialize to factory default settings: Power on, unlocked, display channel 11, channel

ring set to 4, 5, and 11, Group 0. Note that this command works even if TV power is

off or control is locked out.

Shows Net RX if receiving the iC-HE's "heartbeat" pulse once per second, !NET RX

if not. Also displays receive signal strength in the ICC2.

The following commands are used for the ICC2 only

Enable constant Net transmit to the Head-End. This is used for measuring the signal

strength of the ICC2 unit's RF output. Press Enter to stop transmitting, or the unit

will automatically stop after 50 seconds.

Display ICC2 transmitter frequency control voltage – should be 2000 - 3150.

Display DF transmitter frequency deviation – should be 245 - 300.

ICC/ICW Smart TV Controller