APlusLift HW-10KOH Installationshandbuch & Betriebsanleitung - Seite 12
Blättern Sie online oder laden Sie pdf Installationshandbuch & Betriebsanleitung für Hebesysteme APlusLift HW-10KOH herunter. APlusLift HW-10KOH 17 Seiten. 2-post over head car lift 10,000lb capacity
Auch für APlusLift HW-10KOH: Handbuch für Installation und Betrieb (20 seiten)
Seite drucken
FINAL ASSEMBLY
•
Check all bolts and nuts to make sure they are tight. Do not use an impact gun on concrete Anchors.
•
Check all fittings or leaks. If necessary, make sure the arm lock restraints are engaging properly and smoothly. If
not, tap the main lock forward or backward as needed with a rubber mallet to insure proper engagement on all 4 gears with
the arm restraint locks.
•
Cycle lift up and down to insure carriages are synchronized.
•
Place a vehicle on the lift and raise until swivel pads are contact with frame of the vehicle. Raise the vehicle about
3 feet and lower until the tires touch the floor. Keep raising and lowing the vehicle. Increase the height each time until the
vehicle is completely to top. This procedure pumps all the air from the system.
TESTING AND ADJUSTING LIFT
•
With the power properly hooked up and hydraulic oil in the Pump Reservoir, push the Push Button on the side of
the Motor to raise the Carriages off the locks. Release the Push Button and then pull the Lock Release Cable under each
carriage to release the locks. Run the lift all the way up and down two more times to bleed all the air from the system.
•
While running the lift, listen to safeties clicking. Each side should click simultaneously or with-in a 1/2 second of
each other. If they are not clicking together, then adjust the cables to compensate by tightening the side opposite the one
that is clicking last at the cable bolt at the top of the carriage on the same side.
Remember not to over tighten cables – they should be firm, much like a banjo string or a fan belt in a car.
•
•
Now the lift is ready for use.
OPERATION
Only authorized personnel are to operate lift
Read operating and safety procedures manual completely before operating lift.
•
Properly maintain and inspect lift in accordance to owner's manual.
•
Do not operate a lift that is damaged or in need of repair.
•
Allow only authorized personnel in the lift bay.
•
Stay clear of Lift when raising or lowering (NO RIDERS)
•
Keep hands and feet away from pinch points at all times.
•
Never override the Lifts operating and safety controls.
•
If a vehicle is suspected of falling, clear area immediately.
•
Do not rock vehicle while positioned on lift.
•
Always use safety jack stands when removing or installing heavy components.
Vehicle Loading
•
Position vehicle for proper weight distribution (center of gravity should be midway between adapters).
•
Swing arms under vehicle to allow adapters to contact at the manufacturer's recommended pick up points.
•
Use caution before lifting pickup trucks, SUV's and other framed vehicles.
•
The individual axle weight capacity should not exceed 1/2 of lift capacity.
•
Make sure vehicle is neither front nor rear heavy.
•
Make sure the lifting pads are in a proper and safe position to support the vehicle.
Raising Lift
12