APlusLift HW-10KOH Installationshandbuch & Betriebsanleitung - Seite 14
Blättern Sie online oder laden Sie pdf Installationshandbuch & Betriebsanleitung für Hebesysteme APlusLift HW-10KOH herunter. APlusLift HW-10KOH 17 Seiten. 2-post over head car lift 10,000lb capacity
Auch für APlusLift HW-10KOH: Handbuch für Installation und Betrieb (20 seiten)
•
If the safety latch in either column does not operate. Use the following procedure to adjust it.
•
Raise the lift until you can see the latch through the access hole in side of the column by removing the plastic cover.
•
DO NOT set lift on safety latch for this adjustment. Allow the hydraulic system to hold the lift during the adjustment.
DO NOT have a vehicle on the lift during this time.
•
Put the latch forward with a screwdriver.
•
If the latch, is not working during descent, loosen the adjustment bolt one full turn and test the latch and follow this
procedure until the latch operates.
•
If the latch is not working during ascent, tighten the adjustment bolt one full turn and test the latch and follow this
procedure until the latch operates.
•
Latch and or cable adjustments are normal maintenance and not warranty items.
AUTOMOTIVE LIFT SAFETY TIPS
•
Never allow unauthorized persons to operate lift. Thoroughly train new employees in the use and care of lift.
•
Caution - the power unit operates at high pressure.
•
Remove passengers before raising vehicle.
•
Prohibit unauthorized persons from being in shop area while lift is in use.
•
Total lift capacity is 10,000 lbs. @ 2,500 lbs per lifting pad. Do not exceed maximum weight capacity of lift.
•
Prior to lifting vehicle, walk around the lift and check for any objects that might interfere with the operation of lift
and safety latches; tools, air hoses, shop equipment.
•
When approaching the lift with a vehicle, make sure to center the vehicle between the columns so that the tires will
clear the swing arms easily.
•
Slowly drive the vehicle between the columns. It is recommended to have someone outside the vehicle guide the
driver.
•
Always lift vehicle using all four pads.
•
Never use lift to raise one end or side of vehicle.
•
Always raise vehicle about 3" and check stability by rocking vehicle.
•
Prior to lowering vehicle, walk around the lift and check for any objects that might interfere with the operation of
lift and safety latches; tools, air hoses, shop equipment.
•
Always lower lift to the lock position before going under vehicle.
•
Never allow anyone to go under the lift when raising or lowering.
THE PROPER OPERATION OF THE LIFT REQUIRES THAT ANY TIME YOU RAISE A VEHICLE TO WORK ON IT. YOU
MUST LOWER THE LIFT ONTO THE SAFETY LOCKS. This is done by raising the vehicle to the desired height and lowering
the lift by pressing the lowering lever until the arms stop on the next available lock.
NEVER WORK UNDER OR NEAR THIS LIFT WITHOUT THE LOCKS BEING ENGAGED. THE POWER UNIT IS NOT
DESIGNED TO BE A LOADING-HOLDING DEVICE. NOT USING THE LOCKS WILL RESULT IN A PREMATURE
FAILURE OF THE CYLINDERS, PUMP AND/OR CABLES AND CAN CAUSE SERIOUS PROPETTY DAMAGE OR
PERSONAL INJURY!
FAILURE TO HEED THIS WARNING WILL RESULT IN IMMEDIATE TERMINATION OF YOUR WARRANTY!
14