Addonics Technologies RTIV535HEU3 RAID Tower IV Benutzerhandbuch - Seite 2

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Disk-Array-System Addonics Technologies RTIV535HEU3 RAID Tower IV herunter. Addonics Technologies RTIV535HEU3 RAID Tower IV 9 Seiten.

Disk Array Features:

1: Temperature LED and Alarm Reset. When the
temperature inside the Disk Array exceeds 60°C,
An alarm will sound and this LED will glow red.
Pressing the RESET button will silence the alarm
and turn off the LED.
2-5: Power Switch and LED for each individual
drive.
6: Drive lever safety lock.
Installing drives into the
RAID Tower IV
For the Disk Array 3SA:
1. Secure the drive into the tray using the flat
screws as shown.
2. Slide the tray into the bay with the lever open
as shown. When the tray slides all the way into the
bay, close the lever gently until it snaps into
position. It is recommended to lock the lever in the
closed position by turning the safety lock to the
locked position.
For each Snap-In Mobile Rack:
1. Be sure the lock on each drive door is in an
unlock position. If not, use the key that came
with the Raid Tower to unlock the drive door. Pull
on the door lever to swing open the drive door all
the way.
2. Slide a 3.5" SATA hard drive into the drive slot
with the drive connector side facing in and the label
side up. The drive should slide all the way into
the slot with very little resistance. Forcing the
drive into the slot will cause permanent damage
to the drive or the Snap-In enclosure.
3. Once the drive is all the way into the drive slot,
close the door all the way till the drive door latches
securely. Lock the drive door with the key. This will
engage power and data connection with the hard
drive.
4. To remove the hard drive from the enclosure,
simply follow the step 2 – 3 in reverse.
www.addonics.com
Technical Support (M-F 8:30am - 6:00pm PST)
Phone: 408-453-6212
Email: www.addonics.com/support/query/