Addonics Technologies RTIV535HEU3 RAID Tower IV Manual del usuario - Página 2

Navegue en línea o descargue pdf Manual del usuario para Sistema de matriz de discos Addonics Technologies RTIV535HEU3 RAID Tower IV. Addonics Technologies RTIV535HEU3 RAID Tower IV 9 páginas.

Imprimir página

Disk Array Features:

1: Temperature LED and Alarm Reset. When the

temperature inside the Disk Array exceeds 60°C,

An alarm will sound and this LED will glow red.

Pressing the RESET button will silence the alarm

and turn off the LED.

2-5: Power Switch and LED for each individual

drive.

6: Drive lever safety lock.

Installing drives into the

RAID Tower IV

For the Disk Array 3SA:

1. Secure the drive into the tray using the flat

screws as shown.

2. Slide the tray into the bay with the lever open

as shown. When the tray slides all the way into the

bay, close the lever gently until it snaps into

position. It is recommended to lock the lever in the

closed position by turning the safety lock to the

locked position.

For each Snap-In Mobile Rack:

1. Be sure the lock on each drive door is in an

unlock position. If not, use the key that came

with the Raid Tower to unlock the drive door. Pull

on the door lever to swing open the drive door all

the way.

2. Slide a 3.5" SATA hard drive into the drive slot

with the drive connector side facing in and the label

side up. The drive should slide all the way into

the slot with very little resistance. Forcing the

drive into the slot will cause permanent damage

to the drive or the Snap-In enclosure.

3. Once the drive is all the way into the drive slot,

close the door all the way till the drive door latches

securely. Lock the drive door with the key. This will

engage power and data connection with the hard

drive.

4. To remove the hard drive from the enclosure,

simply follow the step 2 – 3 in reverse.

www.addonics.com

Technical Support (M-F 8:30am - 6:00pm PST)

Phone: 408-453-6212

Email: www.addonics.com/support/query/