Apogee Spek Anleitung Handbuch - Seite 4

Blättern Sie online oder laden Sie pdf Anleitung Handbuch für Spielzeug Apogee Spek herunter. Apogee Spek 6 Seiten. Two-stage altitude rocket for altimeters

13. OPTIONAL: Glue the green engine
block into the tube, 1-1/4 inches (3.2cm)
deep. To save weight, you can leave out this
piece.
14. Cut out the shock cord anchor from
the front of instruction sheet. Spread glue
on one side. Take the free end of the shock
cord and lay it diagonally across the paper.
Fold it twice on the marked lines, and then
curl it slightly so it will fit into the long tube
with the fins.
15. Glue the shock cord mount into the
front of the long tube with the fins on it.
Make sure it is deep enough to allow the
payload section to be inserted into the tube.
16. Thread the free end of the yellow
shock cord through the hole in the base
of the transition. Tie a big enough knot in
the end of the cord so it can't be pulled out
through the hole. Using thick CyA adhesive,
glue the knot inside the base of the plastic
transition.
17. Cut a piece of tape (packing tape
works great), and lay it under the shock cord
close to the nose cone. Place the end of the
streamer on half of it, and fold the remainder
of the tape over the top. Press on the tape to
make sure it doesn't come up.
18. Roll up the streamer and place it in
the rocket. Put the payload and nose cone
on top. The lower stage can be coupled to
the rocket with the red coupler or it can be
painted separately. Roll a piece of paper and
insert it into the back of the rocket to hold
the model while you paint it. We recommend
a fluorescent color like orange, pink or yel-
low to make it easier to find the rocket after
touchdown. Allow the paint time to dry.
Congratulations! Your Spek rocket is now
complete.
Page 4
13
14
15
16
17
18
1-1/4" (3.2cm)
1.0" (2.5cm) minimum