Duren 321240 Gebrauchsanweisung - Seite 10

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Farbspritzgerät Duren 321240 herunter. Duren 321240 13 Seiten. Electric hvlp turbine spray gun system

Seite drucken
321240
Instruction Manual

Accessories Included

Shoulder Strap
1
Viscosity Cup
1
Trouble Shooting
Problem
Motor works but spraying is irregular or there is 1 Pick-up pipe in wrong position.
no spraying.
Poor atomization.
Over Painting.
Motor louder than normal.
No spray, no sound.
Sound not right.
"Orange Skin" excessive fogging.
Environmental Protection (W.E.E.E.)
The Waste Electrical & Electronic Equipment Regulations (WEEE) requires that any of our products
showing this marking (left) must not be disposed of with other household or commercial waste. To
prevent possible harm to the environment or human health from uncontrolled waste disposal, please
separate any such product from other waste types and recycle it responsibly at your local facilities.
Check with your Local Authority, Recycling Centre or retailer for recycling advice.
Cause(s)
2 Pick-up pipe blocks.
3 Blocked nozzle.
4 Flow needs adjusting.
1 Pattern poorly adjusted.
2 Paint too thick.
1 Spraygun not clean or not lubricated
resulting in piston getting stuck in cylinder.
2 Too much paint.
3 Viscosity too low.
Spraygun not clean or not lubricated
resulting in piston getting stuck in cylinder.
No electricity.
1 Pattern poorly adjusted.
2 Not enough paint in cup.
3 Paint incorrect viscosity or not getting
through pick-up pipe properly.
1 Incorrect solvent used.
2 Spraygun too close to surface.
3 Paint too think.
Duren Tools
T: 01582 484875 E: [email protected]
www.duren.co.uk
Solution(s)
1 Re-adjust pick-up pipe.
2 Clean pick-up pipe.
3 Clean nozzle.
4 Adjust flow with dial at the rear of spraygun.
1 Re-adjust pattern.
2 Thin paint in accordance with instructions on previous
page.
1 Lubricate and service gun, clean with thinner.
2 Adjust flow with dial at the rear of spraygun.
3 Add paint and check paint in accordance with instructions
on previous page.
Lubricate and service gun, clean with thinner.
Check power supply.
1 Re-adjust pattern.
2 Refill.
3 Check pick-up pipe and viscosity.
1 Use correct solvent. Thoroughly clean gun.
2 Hold gun in accordance with instructions.
3 Thin paint in accordance with instructions on previous
page.