Data Harvest EASYSENSE V-Hub Referenzhandbuch - Seite 9
Blättern Sie online oder laden Sie pdf Referenzhandbuch für Datenlogger Data Harvest EASYSENSE V-Hub herunter. Data Harvest EASYSENSE V-Hub 15 Seiten.
Seite drucken
EASYSENSE V-Hub Reference Manual
V-Hub are compatible with IEEE 802.11n.
Supports WPA-Personal (TKIP) and WPA2-Personal (AES) Security (802.11i)*
Frequency Range: 2412-2462 MHz
Channels supported: 1 to 11
*V-Hub Wi-Fi will automatically detect and use the required security protocol.
Hereby, Data Harvest Group Ltd., declares that V-Hub Wi-Fi is in compliance with the essential
requirements and other relevant provisions of Directive 2014/53/EU
A full copy of the Declaration of Conformity can be obtained by writing to the following address:
Data Harvest Group Ltd.,1 Eden Court, Leighton Buzzard, Bedfordshire, LU7 4FY, UK.
Care & Maintenance
Clean with a damp cloth, do not immerse in water or detergent. V-Hub is not waterproof.
Do not subject to extreme heat or cold or leave in a location where it will get wet.
Do not place your logger in an environment in which high humidity levels are possible as this may
result in damage or malfunction
If V-Hub has been left in the cold, let it warm to near room temperature before waking it from sleep.
Do not expose to direct sunlight for extended periods of time.
Do not expose to temperatures greater than 60˚C, e.g. near a heater or inside a car in hot weather.
Do not store V-Hub with its battery fully discharged. Ideally V-Hub should be stored at least 40% or
more state-of-charge.
Updating EASYSENSE V-Hub's Firmware
Occasionally Data Harvest may release updated firmware which will contain improvements or new
features. Updates will be made available from the
your EASYSENSE V-Hub logger:
Step 1. Download the Firmware Update for V-Hub onto the hard disc of your computer, decompress (e.g.
Extract All) and then run the .exe.
Step 2. Connect V-Hub to the computer using the
USB cable.
A tick will indicate if the process was successful.
Disconnect V-Hub. To repeat this process, connect
another V-Hub and click on the update window.
Data Harvest Group Ltd, 2017
Data Harvest
website. To update the firmware of
Step 3. Wait for a few seconds. A progress bar
will indicate V-Hub is being programmed.
A cross will indicate that an error occurred. Click
on the update window to go back to the start
screen and re-program.
9
DO260 (2)