Data Harvest EASYSENSE V-Hub Referentiehandleiding - Pagina 9

Blader online of download pdf Referentiehandleiding voor {categorie_naam} Data Harvest EASYSENSE V-Hub. Data Harvest EASYSENSE V-Hub 15 pagina's.

EASYSENSE V-Hub Reference Manual

 V-Hub are compatible with IEEE 802.11n.

 Supports WPA-Personal (TKIP) and WPA2-Personal (AES) Security (802.11i)*

 Frequency Range: 2412-2462 MHz

 Channels supported: 1 to 11

*V-Hub Wi-Fi will automatically detect and use the required security protocol.

Hereby, Data Harvest Group Ltd., declares that V-Hub Wi-Fi is in compliance with the essential

requirements and other relevant provisions of Directive 2014/53/EU

A full copy of the Declaration of Conformity can be obtained by writing to the following address:

Data Harvest Group Ltd.,1 Eden Court, Leighton Buzzard, Bedfordshire, LU7 4FY, UK.

Care & Maintenance

 Clean with a damp cloth, do not immerse in water or detergent. V-Hub is not waterproof.

 Do not subject to extreme heat or cold or leave in a location where it will get wet.

 Do not place your logger in an environment in which high humidity levels are possible as this may

result in damage or malfunction

 If V-Hub has been left in the cold, let it warm to near room temperature before waking it from sleep.

 Do not expose to direct sunlight for extended periods of time.

 Do not expose to temperatures greater than 60˚C, e.g. near a heater or inside a car in hot weather.

 Do not store V-Hub with its battery fully discharged. Ideally V-Hub should be stored at least 40% or

more state-of-charge.

Occasionally Data Harvest may release updated firmware which will contain improvements or new

features. Updates will be made available from the

your EASYSENSE V-Hub logger:

Step 1. Download the Firmware Update for V-Hub onto the hard disc of your computer, decompress (e.g.

Extract All) and then run the .exe.

Step 2. Connect V-Hub to the computer using the

USB cable.

A tick will indicate if the process was successful.

Disconnect V-Hub. To repeat this process, connect

another V-Hub and click on the update window.

 Data Harvest Group Ltd, 2017

Data Harvest

website. To update the firmware of

Step 3. Wait for a few seconds. A progress bar

will indicate V-Hub is being programmed.

A cross will indicate that an error occurred. Click

on the update window to go back to the start

screen and re-program.

DO260 (2)