DURKOPP ADLER 610-10 Zusätzliche Anweisungen - Seite 7
Blättern Sie online oder laden Sie pdf Zusätzliche Anweisungen für Nähmaschine DURKOPP ADLER 610-10 herunter. DURKOPP ADLER 610-10 14 Seiten. Replacing the dc motor at the tape unwinder
Seite drucken
Replacing the DC motor at the tape unwinder
3. Loosen the screws (4) on the circuit board (3).
4. Carefully pull out the circuit board (3) until you can access the motor
5. Pull the motor cable (5) and the cable of the proximity switch (6) off
Fig. 3: Disassembling the old motor (3)
⑦
(7) - Drive roller
(8) - Screws
6. Loosen the screws (8) on the drive roller (7).
7. Remove the driver roller (7).
8. Loosen nuts (9) and washers.
9. Remove the entire motor bracket.
Fig. 4: Disassembling the old motor (4)
(10) - Screws
10. Loosen the screws (10).
11. Take out the old motor (11).
Additional Instructions 610-10 - 00.0 - 04/2019
cable (5).
While doing so, make sure not to tear off any cables.
the circuit board (3).
⑩
⑧
(9) - Nuts
(11) - Old motor
⑨
⑪
5