- ページ 7

ミシン DURKOPP ADLER 610-10のPDF 補足説明をオンラインで閲覧またはダウンロードできます。DURKOPP ADLER 610-10 14 ページ。 Replacing the dc motor at the tape unwinder

Replacing the DC motor at the tape unwinder

3. Loosen the screws (4) on the circuit board (3).

4. Carefully pull out the circuit board (3) until you can access the motor

5. Pull the motor cable (5) and the cable of the proximity switch (6) off

Fig. 3: Disassembling the old motor (3)

⑦

(7) - Drive roller

(8) - Screws

6. Loosen the screws (8) on the drive roller (7).

7. Remove the driver roller (7).

8. Loosen nuts (9) and washers.

9. Remove the entire motor bracket.

Fig. 4: Disassembling the old motor (4)

(10) - Screws

10. Loosen the screws (10).

11. Take out the old motor (11).

Additional Instructions 610-10 - 00.0 - 04/2019

cable (5).

While doing so, make sure not to tear off any cables.

the circuit board (3).

⑩

⑧

(9) - Nuts

(11) - Old motor

⑨

⑪