CAVE TeamUp TX20i Benutzerhandbuch - Seite 10
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Sicherheitskamera CAVE TeamUp TX20i herunter. CAVE TeamUp TX20i 20 Seiten. 4k ptz camera
Auch für CAVE TeamUp TX20i: Handbuch zur Schnelleinrichtung (4 seiten)
Seite drucken
CAVE-TEK TeamUp TX20i Camera
Auto Scan Shoot: On, Off.
Auto Inversion: On, Off.
SDI-3G Mode: LEVEL-A, LEVEL-B.
Tracking Mode: On, Off.
Tally Mode: On, Off.
4.8 COMMUNICATION SETUP
Move the main menu cursor to [COMMUNICATION SETUP], and press [HOME] key enter the
communication setup page, as shown in the following figure.
Protocol: Control protocol type, Auto, VISCA, PELCO-D, PELCO-P.
V_Address: 1 ~ 7. (Effective only in Auto, VISCA protocol).
V_AddrFix: On, Off (When set to On, useless in 88 30 01 FF Command).
P_D_Address: 0 ~ 254. (Effective only in PELCO-D protocol).
P_P_Address: 0 ~ 31. (Effective only in PELCO-P protocol).
Net Mode: Set the serial port network control, Serial, Paral.
Baudrate: Serial port baud rate, 2400, 4800, 9600, 38400.
4.9 RESTORE DEFAULT
Move the main menu cursor to [RESTORE DEFAULT], and press [HOME] key enter the restore default page,
as shown in the following figure.
Restore: Confirm restore factory settings, Yes, No.
Note: Press [HOME] button to confirm, all parameter restore default, include IR Remote address and VISICA
address.
COMMUNICATION SETUP
Protocol
V_Address
V_AddrFix
Net Mode
Baudrate
Select Item
Change Value
[Menu] Back
RESTORE DEFAULT
Restore?
Change Value
[Home] OK
[Menu] Back
8
VISCA
1
Off
Serial
9600
No
User Guide