Cayken SCY-98HD Gebrauchsanweisung - Seite 4

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Bohrer Cayken SCY-98HD herunter. Cayken SCY-98HD 8 Seiten. Industrial equipment

Seite drucken

、ELECTRICAL SAFETY

Tool before connecting power, using the socket must be able to fit the plug machine. The

380V model to determine the fire and. Line the correct docking, power supply socket with the

need of professionals to complete. Do not arbitrarily change the plug, adapter plugs can't pick.

The electric tool wire used together.

、SAFETY INSTRUCTIONS

Warning labels and/or other labels on the machine must be replaced when they were removed.

Do not operate the machine at insufficient lighting conditions

Do not operate the machine outdoors

Do not operate the machine when you are tired, when your concentration

is impaired, and/ or under the influence of drugs, medication or alcohol.

Climbing onto the machine is forbidden! Heavy injuries by falling down

or by tilting of the machine are possible.

The machine shall be used only by trained persons

Non authorized persons, especially children, shall be kept away from

the work area.

Do not wear loose clothing long hair openly or loose jewellery like

neck laces etc when operating the machine

They might be catched by rotating parts and cause serious injuries.

、INSTRUCTIONS

1 .Plug the power plug the drill bit aim at processing position make the magnetic switch is

opened so that the magnetic is adsorbed on the surface of steel plate magnetic materials

No impurities on the surface and check whether the attractive force is normal or not ge-

neral plate thickness should be more than 10mm

2 .Please placed the magnetic base drill required from the drilling near site and select the appro

priate adsorption material And will handle hole safety rope penetrates into the frame the

other one is in fastening frame after the penetration of the buckle and then close the safety

rope buckle Hand and pull off should not loose and mobile

3 .For a support screw regulating the support screw that the bottom touches the workpiece

surface

4. For the magnetic base is provided with the angle of the drill the use of angle wrench movem-

ent angle disk in the annex to the belt rack makes bit central alignment processing position

tighten the angle wrench

5 .Open the electric drill switch check whether the drill bit beat sound is normal if everything is

normal can turn the handle to feed

6. Start feeding should be slow gives the quantity of about 0 05mm r in general not too much

force to prevent overload

7. If the drill suddenly stopped you must turn off the power switch immediately Mustclose

the magnetic control switch

8 Please shut down for a period of time machine in continuous use for 2 3 hours in case mag-

netic base is overheated and leakage or burned

9.Should be filled with cooling water or cooling liquid using hollow drill turn on the tap and let

it flow out slowly

Use proper safety clothing and devices when operating the machine

(, safety goggles, ear protectors, safety shoes ...)! Do not wear safety

gloves for oper-ating because they decrease the working accuracy

and they might be pulled into the saw blade.

Before any maintenance you have to disconnect the panel saw from

the power source. Never use the plugged cable for transporting or

manipulating the machine.

)

. (

, (