Dust Free 06159 Handbuch für Installation und Betrieb - Seite 4

Blättern Sie online oder laden Sie pdf Handbuch für Installation und Betrieb für Beleuchtungsanlagen Dust Free 06159 herunter. Dust Free 06159 9 Seiten. 21", 33", 45" ultraviolet light systems

Seite drucken

BIO-FIGHTER® 4XTREME INSTALLATION & OPERATION MANUAL

DEVICE ORIENTATION

The NEMA 4X enclosure of the device allows it

to be installed outdoors, either horizontally or

vertically, and remain weatherproof.

For applications where the device is mounted

horizontally, the tilt-lamp configuration is rec-

ommended. The device comes pre-configured

for tilt-lamp operation. This configuration pro-

vides greater UV-C exposure into the drain

pan condensate. (See Fig. 1)

For vertical applications the device may be

installed in its tilt-lamp or straight-lamp config-

uration. (See Fig. 2)

Fig. 1 For horizontal installations use the tilt-lamp configuration

for greater UV-C exposure into the drain pan.

Fig. 2 For vertical installations use either the straight-lamp or tilt-

lamp configuration. Note: Removal of lower slide clip is

required for straight-lamp configuration.

CAUTION

UV-C Light May Degrade Plastic and Rubber.

Shield exposed plastic drain pans, wire insu-

lation, flex duct, or other plastic/rubber com-

ponents from UV-C light.

ENCLOSURE MOUNTING

Tape the provided mounting template at the

desired installation location. Use this template

to mark locations for the lamp hole and

mounting screw pilot holes. Remove the tem-

plate after use.

Use a 1.125" - 1.25" drill bit or holecutter to

make the lamp hole. Use a 3/32" drill bit to

make the pilot holes for the mounting screws.

Once the holes are drilled apply a sealer suit-

able for outdoor use around the mounting

holes. Check to make sure the surface is flat

to provide a good seal for the gasket and

position the enclosure so that all holes align.

Use #10 x 5/8" or longer sheet metal screws

and washers to mount the device to the air

handling system.

Fig. 3 Mount the device using #10 x 5/8" or longer sheet metal

screws and washers. Be sure to use weatherproof sealant around

the mounting holes if installing outdoors.

WARNING

UV-C Light Hazard.

UV-C light can cause temporary or perma-

nent loss of vision, and sunburn. To prevent

exposure, do not install device in any appli-

cations that allows UV-C light to be visible

after installation.

(Fig.3 )