Dust Free 06159 Manuale di installazione e funzionamento - Pagina 4
Sfoglia online o scarica il pdf Manuale di installazione e funzionamento per Apparecchiature di illuminazione Dust Free 06159. Dust Free 06159 9. 21", 33", 45" ultraviolet light systems
Stampa la paginaBIO-FIGHTER® 4XTREME INSTALLATION & OPERATION MANUAL
DEVICE ORIENTATION
The NEMA 4X enclosure of the device allows it
to be installed outdoors, either horizontally or
vertically, and remain weatherproof.
For applications where the device is mounted
horizontally, the tilt-lamp configuration is rec-
ommended. The device comes pre-configured
for tilt-lamp operation. This configuration pro-
vides greater UV-C exposure into the drain
pan condensate. (See Fig. 1)
For vertical applications the device may be
installed in its tilt-lamp or straight-lamp config-
uration. (See Fig. 2)
Fig. 1 For horizontal installations use the tilt-lamp configuration
for greater UV-C exposure into the drain pan.
Fig. 2 For vertical installations use either the straight-lamp or tilt-
lamp configuration. Note: Removal of lower slide clip is
required for straight-lamp configuration.
CAUTION
UV-C Light May Degrade Plastic and Rubber.
Shield exposed plastic drain pans, wire insu-
lation, flex duct, or other plastic/rubber com-
ponents from UV-C light.
ENCLOSURE MOUNTING
Tape the provided mounting template at the
desired installation location. Use this template
to mark locations for the lamp hole and
mounting screw pilot holes. Remove the tem-
plate after use.
Use a 1.125" - 1.25" drill bit or holecutter to
make the lamp hole. Use a 3/32" drill bit to
make the pilot holes for the mounting screws.
Once the holes are drilled apply a sealer suit-
able for outdoor use around the mounting
holes. Check to make sure the surface is flat
to provide a good seal for the gasket and
position the enclosure so that all holes align.
Use #10 x 5/8" or longer sheet metal screws
and washers to mount the device to the air
handling system.
Fig. 3 Mount the device using #10 x 5/8" or longer sheet metal
screws and washers. Be sure to use weatherproof sealant around
the mounting holes if installing outdoors.
WARNING
UV-C Light Hazard.
UV-C light can cause temporary or perma-
nent loss of vision, and sunburn. To prevent
exposure, do not install device in any appli-
cations that allows UV-C light to be visible
after installation.
4
(Fig.3 )