CBT Supply SFI-363030-TKF Montageanleitung - Seite 4

Blättern Sie online oder laden Sie pdf Montageanleitung für Inneneinrichtung CBT Supply SFI-363030-TKF herunter. CBT Supply SFI-363030-TKF 5 Seiten. Fiip-it series

Seite drucken

c CBT Supply Inc.

Figure 7 Smartdesks Flip-it Series Single Station with

Back & Side Panels assembled.

STEP 3 - Center Support Panel (CPU)

Cabinet Assembly

NOTE: 1 person assembly required for proper fit.

Hold Center Support Panel in 90 o vertical position with

the corner notch facing away from Back Panel. (This

allowance is for the Keyboard/Hinge Mechanism.) Match

RV Fittings to one another and snap panel into place.

Use power drill to tighten the screw contained in the RV

Fitting. (Fig. 8) Cam Pin holes in Back Panel should

align with Cams in Center Support Panel. Insert Cam

Pin through back panel into cam fitting. (Fig. 9) You

may have to flex Back Panel up and down slightly to get

Cam Pin to slide into hole. Tighten with screwdriver until

it locks into place. Check to verify that the arrow is facing

out. Repeat this step for remaining Cam Pin. The Center

Support Panel is now locked into position.

If ordered a model with 2 Center Support Panels, repeat

STEP 3 for the installation of remaining support panel.

Figure 9

SFI Single Workstations

Figure 7

Figure 8

Cam pin is inserted through

panel into preinstalled fitting.

STEP 4 - Installation of CPU Bottom

NOTE: 1 person assembly required for proper fit.

The CPU Bottom is not adjustable. Make sure arrows

on Cams are facing out. Slide the CPU bottom into

position. (Fig10) Aligning the CPU Bottom with the

predrilled holes, insert Cam Pin through the CPU Side

Panel into cam fitting. Tighten with screwdriver until it

locks into place. Repeat this step for remaining 3 Cam

Pins. (Fig. 11)

Figure 10

Check to verify that arrow is pointing

perpendicular to pin when cam is locked.

Flip-it Single Series

Page 4

Figure 11