Dux ProFlo 160T124 Benutzerhandbuch - Seite 3
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Warmwasserbereiter Dux ProFlo 160T124 herunter. Dux ProFlo 160T124 16 Seiten. Electric storage water heaters
Auch für Dux ProFlo 160T124: Benutzerhandbuch (16 seiten), Benutzerhandbuch (16 seiten)
Seite drucken
Owner's Manual – Proflo Electric Storage Water Heaters
Installation Requirements
General:
This water heater must be installed
by a licensed tradesperson, and in
accordance with:
•
AS/NZS 3500.4 Plumbing and
Drainage – Heated Water Services.
•
Clause G12 of the NZ Building
Code (in New Zealand).
•
AS/NZS 3000 Electrical Installations
(known as the Australian / New
Zealand Wiring Rules).
•
Local authority regulations.
•
Outside Australia and New Zealand,
please refer to local plumbing and
building codes and regulations.
Failure to comply with these
requirements may affect the warranty.
Note for Victoria:
This water heater must be installed by
a licensed person as required by the
Victorian Building Act (1993).
Only a licensed person will provide a
compliance certificate, showing that
the work complies with all the relevant
Standards. Only a licensed person
will have insurance protecting their
workmanship.
Pool Heating:
This water heater must not be used for
pool heating.
H0421
0421
Rev. N
Location:
The water heater should be located as
close as possible to the most frequently
used hot water outlet.
Ensure the compliance plate and
associated warnings are clearly visible.
The water heater must be accessible
without the use of a ladder or scaffold.
Adequate clearance must be available
for service to the element, thermostat,
relief valve and anode. All models are
equipped with a sacrificial anode, allow
half of the height of the water heater to
provide access through the top cover.
Electric storage water heaters may be
installed indoors. A properly drained
safe tray must be installed where
property damage could occur from
water spillage. Refer to AS/NZS 3500.4
for further information.
Note - the warranty will not cover
damage due to leakage of the water
heater if a properly drained safe tray has
not been installed.
Refer to local regulations before
installing the water heater in a roof
space.
Water Heater Support:
The water heater must be installed on
a flat, solid supporting surface. The
pipework must not be used to support
the water heater.
Where the water heater is subjected
to wet conditions, a plinth should be
installed under the water heater.
1