Dux ProFlo 160T124 Benutzerhandbuch - Seite 8

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Warmwasserbereiter Dux ProFlo 160T124 herunter. Dux ProFlo 160T124 16 Seiten. Electric storage water heaters
Auch für Dux ProFlo 160T124: Benutzerhandbuch (16 seiten), Benutzerhandbuch (16 seiten)

Seite drucken

Owner's Manual – Proflo Electric Storage Water Heaters

Electrical Connection

General:

This water heater is designed for single

phase 240V a.c. supply only. The

electrical connection must comply with

Local Supply Authority Regulations and

AS/NZS 3000.

Connection of the electrical wiring

must only be carried out by a licensed

tradesperson.

Connections are made at the terminal

block under the water heater electrical

cover. A means for disconnection must

be incorporated in the fixed wiring in

accordance with the Wiring Rules.

Removing the Electrical Cover:

Before removing the electrical cover,

ensure the electrical power supply is

safely isolated.

The electrical cover is removed by

undoing the two screws at the bottom

of the cover and sliding the cover

downwards to disengage the top edge.

Connections:

The cable entry is a pre-punched hole

designed to accept a 20 mm conduit

gland. It is located adjacent to the

terminal block.

To prevent damage to the wiring, the

cable entry must be fitted with a gland

prior to feeding the wiring through the

hole. Ensure the conduit entry is sealed

correctly.

Connect the active and neutral wires to

the terminal block and the earth wire to

the earth tab (located on the right hand

side). Excess wire is not to be looped

close to the thermostat or tank.

Replacing the Electrical Cover:

1. Press the reset button on the

thermostat to ensure the over-

temperature energy cut-out is set.

2. Check the Pressure & Temperature

Relief Valve, both of the brass plugs,

and their clear plastic packaging

have been removed from inside the

cover.

3. Ensure the terminal block mounting

plate is horizontal.

4. Slide the cover up, ensuring the top

edge engages under the case.

5. Swing the cover down until the

bottom edge contacts the case.

Ensure the terminal block mounting

plate is below the pins located

inside the cover.

6. Refit and tighten both screws in the

cover.

Ensure the water heater is filled

with water before turning on the

electricity supply.

H0421

0421

Rev. N