Agri-Fab 45-02102 Benutzerhandbuch - Seite 6
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Streuwagen Agri-Fab 45-02102 herunter. Agri-Fab 45-02102 13 Seiten. 125 lb. push broadcast spreader
Auch für Agri-Fab 45-02102: Benutzerhandbuch (13 seiten)
Seite drucken16. Assemble the flow control arm to the flow control
mounting bracket using a 1/4" x 3/4" hex bolt, two
nylon washers and a 1/4" hex lock nut as shown in
figure 7. Tighten carefully. The flow control arm
should be snug, but should pivot with no more than
a slight resistance.
17. Assemble the vinyl grip. See figure 7.
VYNIL GRIP
FLOW
CONTROL
ARM
1/4" x 3/4"
HEX BOLT
(2) NYLON
WASHERS
FIGURE 7
18. Place a 5/16" flat washer onto the end of the flow
control rod. Insert the end of the rod through the
slot in the flow control mounting bracket and through
the hole in the flow control link. Secure with a 3/32"
x 3/4" cotter pin. See figure 8.
5/16" FLAT
WASHER
FLOW
CONTROL
ROD
FIGURE 8
FLOW CONTROL
MOUNTING
BRACKET
1/4" HEX
LOCK NUT
3/32"
COTTER
PIN
SLOT
FLOW
CONTROL
LINK
19. Hook free end of flow control rod through hole in
slide gate bracket located near bottom of hopper.
See figure 9.
HOPPER
FIGURE 9
20. Assemble both the flow control mounting bracket
and the short handle tube to the long handle tube
using two 1/4" x 1-3/4" hex bolts, four 5/16" flat
washers and two 1/4" hex lock nuts. Do not tighten
at this time. See figure 10.
21. Place a handle grip on each handle. See figure 10.
HANDLE GRIP
1/4" x 1-3/4"
HEX BOLT
HANDLE
TUBE
(SHORT)
HANDLE
TUBE
(LONG)
FIGURE 10
6
SLIDE
GATE
BRACKET
FLOW
CONTROL
ROD
FLOW CONTROL
MOUNTING BRACKET
1/4" HEX
LOCK NUT
5/16"
FLAT
WASHERS