Datavideo DAC-7 Gebrauchsanweisung - Seite 6

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Medienkonverter Datavideo DAC-7 herunter. Datavideo DAC-7 16 Seiten. Analogue to sdi converter
Auch für Datavideo DAC-7: Gebrauchsanweisung (8 seiten)

Seite drucken

Introduction

Thank you for purchasing the DAC-07 Analogue to SD-SDI converter.

The DAC-07 is designed to be an affordable bridge between existing cameras with SD Analogue

Video outputs and SD-SDI equipment or mixers such as the Datavideo SE-900, SE-2800 and

SE-3000.

Due to the nature of SD-SDI signals, single BNC SD-SDI cable runs of up to 100m should be

possible with this unit before the signal would need to be re-clocked or repeated.

The DAC-07 also has the ability to embed two channels of audio (or 1 stereo pair) into the SD-

SDI signal from either unbalanced RCA / Phone connections or balanced 3pin XLR connections.

1.1

Features

Video connections include

•

1x Composite (CVBS), 1x S-Video (Y/C) and 1x Component Y.U.V. (Y,Pb,Pr)

2x SD-SDI (BNC) outputs both with embedded 2 channel audio

•

SD-SDI output signal that complies with the SMPTE259M-C standard at 270 Mbps

Audio connections include

•

Connections for CH1/L and CH2/R on unbalanced RCA / Phone cabling

Connections for CH1/L and CH2/R on balanced XLR cabling

•

12 and 16 bit audio auto recognition

•

Others

Dip switches for video source selection

•

Space saving – mountable between camera and tripod plate

Rugged case design with easy access to Audio and Video connections

•

DC 12V / 0.5A input connector with screw locking thread

NB: Ensure the dip switch settings match the video signal being fed into the DAC-07.

Connecting both XLR and RCA / Phone audio sources at the same time is not recommended.

A separate Time Base Corrector may be required if the unit is fed poor AV signals from tape.

Before operating this device please also refer to the section marked SD-SDI Cabling Advice.