Datavideo DAC-7 사용 설명서 - 페이지 6

{카테고리_이름} Datavideo DAC-7에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Datavideo DAC-7 16 페이지. Analogue to sdi converter
Datavideo DAC-7에 대해서도 마찬가지입니다: 사용 설명서 (8 페이지)

페이지 인쇄
Datavideo DAC-7 사용 설명서
1.

Introduction

Thank you for purchasing the DAC-07 Analogue to SD-SDI converter.
The DAC-07 is designed to be an affordable bridge between existing cameras with SD Analogue
Video outputs and SD-SDI equipment or mixers such as the Datavideo SE-900, SE-2800 and
SE-3000.
Due to the nature of SD-SDI signals, single BNC SD-SDI cable runs of up to 100m should be
possible with this unit before the signal would need to be re-clocked or repeated.
The DAC-07 also has the ability to embed two channels of audio (or 1 stereo pair) into the SD-
SDI signal from either unbalanced RCA / Phone connections or balanced 3pin XLR connections.
1.1

Features

Video connections include
•
1x Composite (CVBS), 1x S-Video (Y/C) and 1x Component Y.U.V. (Y,Pb,Pr)
2x SD-SDI (BNC) outputs both with embedded 2 channel audio
•
•
SD-SDI output signal that complies with the SMPTE259M-C standard at 270 Mbps
Audio connections include
•
Connections for CH1/L and CH2/R on unbalanced RCA / Phone cabling
Connections for CH1/L and CH2/R on balanced XLR cabling
•
12 and 16 bit audio auto recognition
•
Others
Dip switches for video source selection
•
•
Space saving – mountable between camera and tripod plate
Rugged case design with easy access to Audio and Video connections
•
•
DC 12V / 0.5A input connector with screw locking thread
NB: Ensure the dip switch settings match the video signal being fed into the DAC-07.
Connecting both XLR and RCA / Phone audio sources at the same time is not recommended.
A separate Time Base Corrector may be required if the unit is fed poor AV signals from tape.
Before operating this device please also refer to the section marked SD-SDI Cabling Advice.
6