Agri-Fab 45-0324 Benutzerhandbuch - Seite 4

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Streuwagen Agri-Fab 45-0324 herunter. Agri-Fab 45-0324 13 Seiten. Atv mounted 125 lb. broadcast spreader
Auch für Agri-Fab 45-0324: Benutzerhandbuch (12 seiten)

Seite drucken

ASSEMBLY INSTRUCTIONS

TOOLS

REQUIRED

FOR ASSEMBLY

(1)

Pliers

(2)

7/16" Wrenches

(2)

1/2" Wrenches

(2)

9/16" Wrenches

REMOVAL

OF PARTS

FROM CARTON

Remove all parts and hardware

packages from the car-

ton. Lay out all parts and hardware and identify using the

illustrations

on pages 2 and 3.

Turn the spreader upside down as shown in figure 1.

Press the two plugs into the ends of the frame tube.

See figure 1.

HINT:

Use a block of wood to help press the plug down

into the end of the tubing.

Assemble the two angle brackets and two 1/4" nylock

nuts onto the ends of the longer bolts that are already

assemble to the frame tube. Do not tighten

yet. See

figure 1.

1/4"NYLOCK

NUT

ANGLE

BRACKET

FIGURE 1

PLUG

Fasten the deflector

to the angle brackets using two

1/4" x 3/4" hex bolts, 1/4" flat washers and 1/4" nylock

nuts. Allow the angle brackets to swivel so that the

deflector curves naturally between the angle brack-

ets and then tighten

all nuts. See figure 2.

DEFLECTOR

1/4" x 3/4"

HEX BOLT

1/4" FLAT

WASHER

I/4"NYLOCK

NUT

FIGURE 2

Position the spreader

for adequate

clear-

ance

if the vehicle

muffler

discharges

straight

toward the rear.

NOTE:

The top of the hopper should

be at least 30"

above

the ground.

The mounting

holes shown in

figures 3 and 4 will make the top of the hopper even

with the vehicle's rear rack. If exhaust blows against

spreader,

a higher mounting position may help.

IMPORTANT:

Before proceeding, determine if the mount-

ing brackets, when attached directly to the spreader

frame, will fit onto the vehicle rack. If they need to be

farther apart, use the extension brackets in figure 4.

If you are NOT using extension

brackets:

Attach the R.H. mounting bracket to the frame tube

using two 5/16" x 2" hex bolts and 5/16" nylock nuts

as shown in figure 3. Tighten.

Repeat for the L.H.

mounting

bracket.

MOUNTING

BRACKET,

5/16" NYLOCK NUT

FIGURE 3