Agri-Fab 45-0324 Benutzerhandbuch - Seite 5

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Streuwagen Agri-Fab 45-0324 herunter. Agri-Fab 45-0324 13 Seiten. Atv mounted 125 lb. broadcast spreader
Auch für Agri-Fab 45-0324: Benutzerhandbuch (12 seiten)

Seite drucken

If you are using extension

brackets:

Attach

the extension

brackets

to the legs of the

spreader

frame.

Use two 5/16" x 2" hex bolts and

5/16" nylock nuts per bracket. Tighten.

See figure 4.

5/16" NYLOCK NUT

EXTENSION

BRACKET

FIGURE 4

If you are using extension

brackets:

Attach the R.H. mounting

bracket to the extension

bracket shown in figure 5 using two 5/16" xl" hex

bolts and 5/16" nylock nuts. Tighten.

Repeat on the

other frame leg with the L.H. mounting bracket.

Attach

the spreader's

mounting

brackets

to the

vehicle's rear rack using four 5/16" x 1-3/4" carriage

bolts, mounting

clamps and plastic knobs. Use the

adhesive pads to protect the rack. See figure 6.

MOUNTING

BRACKET

-....

5116" x 1-3/4"

CARRIAGE

BOLT

ADHESIVE

PAD

FIGURE 6

Assemble a seal (turned as shown at the top of figure

7) onto the motor shaft. Slide it up against the motor.

10. Assemble

the impeller coupler onto the motor shaft

and secure it with a 1/8" x 1-1/4" cotter pin. Spread

the ends of the pin around the coupler. See figure 7.

11. Assemble the long end of the spreader shaft into the

impeller

coupler and secure it with a 1/8" x 1-1/4"

cotter pin. Spread the ends of the pin around the

coupler. See figure 7.

12. Insert the 1/8" hairpin agitator into the middle hole in

the spreader

shaft. See figure 7.

13. Assemble

the second seal (turned as shown at the

bottom of figure 7) onto the end of the spreader shaft.

FIGURE 5

118" HAIRPIN

AGITATOR

"------..._ <_

SEAL

IMPELLER

COUPLER

SPREADER

SHAFT

SEAL

FIGURE 7