4qd JSK-120 Gebrauchsanweisung - Seite 4

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Controller 4qd JSK-120 herunter. 4qd JSK-120 4 Seiten.

Reassembly

1. Insert the M4 handle retaining screw into the handle and place the handle

face down. Drop the serrated washer onto the part of the screw still visible.

2. Place the spring into its hole and position the ball bearing on top.

3. Apply silicon grease to the bearing surfaces of the drum and insert it into

the collar with the grub screw aligning with the hole. Insert an allen key

through the hole into the grub screw.

4. Place the collar and drum assembly onto the handle.

5. Carefully pick up all three parts and tighten the handle retaining screw.

6. Insert the sensor shaft into the drum, the wires should be at the top,

nearest to the grub screw, the shaft flat should align with the grub screw.

7. Fit the sensor holding screws and then gently tighten the grub screw.

JSK-120 V1.0 05/21

Page 4