4qd JSK-120 사용 설명서 - 페이지 4

{카테고리_이름} 4qd JSK-120에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 4qd JSK-120 4 페이지.

Reassembly

1. Insert the M4 handle retaining screw into the handle and place the handle

face down. Drop the serrated washer onto the part of the screw still visible.

2. Place the spring into its hole and position the ball bearing on top.

3. Apply silicon grease to the bearing surfaces of the drum and insert it into

the collar with the grub screw aligning with the hole. Insert an allen key

through the hole into the grub screw.

4. Place the collar and drum assembly onto the handle.

5. Carefully pick up all three parts and tighten the handle retaining screw.

6. Insert the sensor shaft into the drum, the wires should be at the top,

nearest to the grub screw, the shaft flat should align with the grub screw.

7. Fit the sensor holding screws and then gently tighten the grub screw.

JSK-120 V1.0 05/21

Page 4