4qd PRO-360-S/HV Gebrauchsanweisung - Seite 7

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Controller 4qd PRO-360-S/HV herunter. 4qd PRO-360-S/HV 20 Seiten.

Thermistor input

Can be used to connect 1 or 2 sensors to monitor external temperatures.

Sensor X is connected to C and D, Sensor Y to A and B.

Once the sensors have been installed they must be enabled in the profile menu.

The Pro-360 will accept a standard hobbyist radio control servo signal directly

from a receiver. The receiver should be connected to pins B, C, and D. Pin D is

linked to pin A by Lk1, this can be removed if a 4 wire radio connection is

required.

The Pro-360 is pre-programmed to work with the majority of radio receivers.

Profiles 7 and 8 are configured for RC single ended and RC joystick use.

Depending on your radio system you may need to use the RC learn function to

properly match the Pro-360 to your receiver output.

The RDO port can act as a BEC for currents up to 1A. Pin B of the adjacent BEC

port can be used in parallel to increase this to 2A if required.

PRO-360 V2.3/4 10/20

Sensors X and Y should be 4QD

part number SEN-TMP.

Page 7