ページを印刷する
8.
Thermistor input
Can be used to connect 1 or 2 sensors to monitor external temperatures.
Sensor X is connected to C and D, Sensor Y to A and B.
Once the sensors have been installed they must be enabled in the profile menu.
9.
Radio Control Input and BEC
The Pro-360 will accept a standard hobbyist radio control servo signal directly
from a receiver. The receiver should be connected to pins B, C, and D. Pin D is
linked to pin A by Lk1, this can be removed if a 4 wire radio connection is
required.
The Pro-360 is pre-programmed to work with the majority of radio receivers.
Profiles 7 and 8 are configured for RC single ended and RC joystick use.
Depending on your radio system you may need to use the RC learn function to
properly match the Pro-360 to your receiver output.
The RDO port can act as a BEC for currents up to 1A. Pin B of the adjacent BEC
port can be used in parallel to increase this to 2A if required.
PRO-360 V2.3/4 10/20
Sensors X and Y should be 4QD
part number SEN-TMP.
Page 7
www.4qd.co.uk