Austin Kontore Leopold Bench Kit Montageanleitung - Seite 11

Blättern Sie online oder laden Sie pdf Montageanleitung für Werkzeuglagerung Austin Kontore Leopold Bench Kit herunter. Austin Kontore Leopold Bench Kit 12 Seiten. Children's version

Seite drucken

Using a 1/8" drill bit, drill (2) holes through the back and

into the Leg Assembly. The holes should be about 1 ½"

from the top and bottom edges of the Back.

REPEAT for both sides of the back. Four holes total.

Starting with one end, fasten the Back to the Leg Assembly

using a screw. Make sure that the edges of the Back are

aligned with the Leg. The edges should be flush.

Move to the opposite side of the back, and fasten the back

with another screw. You will probably have the hold the

wood so that everything is aligned.

Once the two screws are fastened, finish the attachment

of the back using the two remaining screws.

Note: It's okay if the Back overlaps a bit, but if it does,

you should sand it down for an improved look.

The Back is now attached to the bench with four screws.

The bench can now be placed upright and tested.

Note: A little bit of "wobble" is normal. When placed on

your lawn the wobble will not be noticeable.

Page 11 of 12