Austin Kontore Leopold Bench Kit Montageanleitung - Seite 9

Blättern Sie online oder laden Sie pdf Montageanleitung für Werkzeuglagerung Austin Kontore Leopold Bench Kit herunter. Austin Kontore Leopold Bench Kit 12 Seiten. Children's version

Seite drucken

The seat will be about ½" to 1" forward. You want it

brought toward the front of the bench, so it overhangs a

bit.

Note: The sharp corner should be sanded down when

you are done with assembly.

Drill two holes at the edge of the seat of the seat, about

½" from the ends, and 1 ½" from the front and rear edges,

making sure that the seat remains in its aligned position.

REPEAT at the other end of the seat.

Note: It will be a little difficult getting a large power drill

in close. A smaller drill will make the job easier.

Fasten the Seat to the Leg Assembly using (4) screws. You

are fastening into the top of the Rear Leg, two screws on

each end.

Important: Make sure that the seat is TIGHTLY

screwed and FLUSH with the upright leg assembly. The

board should be right up against the Front Leg, and sitting

completely on the Rear Leg.

For additional strength, drill two holes on the outside of

the legs. These holes should go though the face of the leg

and into the edge of the seat. You may need to measure

the distance from the floor to determine where to drill. (It

will be approximately 11 ½" from the floor.)

the opposite side of the bench.

From the outside of the leg, use (4) more screws to further

pull the seat to the legs. In total, there will be (8) screws

holding the seat to the legs – four on the top of the seat,

and four from the ends.

REPEAT at

Page 9 of 12