Cookshack PG500 Benutzerhandbuch - Seite 5

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Herde Cookshack PG500 herunter. Cookshack PG500 12 Seiten. Fast eddy pellet cooker

 Shut down procedure: Turn switch to the off position.

ELECTRICAL SPECIFICATIONS

 110 Volt, 60 Hz, single phase, 4 amp service required

 All switches should be in the off position before plugging into proper receptacle

outlet

 The fire pot igniter elements are 200 watts; the auger motor and burner induction

fan are 25 watts each.

 Use foil to cover drip pan and change after each use

 Clean ash from unit after approximately 20 hours of use

 If the cooker is stored outdoors care should be taken to insure that water does not

get into the hopper. Wood pellets expand greatly when wet and will jam your

auger system. A vinyl cover is highly recommended. It will also keep water out

of your ash pan and grease drain bucket.

 When cleaning the inside of the cooker only use a scraper to knock off the heavier

debris. Empty and scrape out the ash pan. A shop vac comes in handy on the fire

pot side of the cooker. Be careful not to damage the wiring coming from the

thermocouple. The dark color it will get is what we call seasoned and actually

enhances the performance of the cooker. It's much like a cast iron frying pan.

When washing the outside of the unit you may use a mild degreaser such as a

simple green or 409 type house hold cleaners. The cooking grates are dishwasher

safe. If using a brush on cooking grates only use a stiff nylon or brass brush.

Anything else may damage the coatings.

 If you start seeing a build up of sawdust in the bottom of the hopper, remove the

pellets and use a shop vac to remove the sawdust. Build up of sawdust will not

allow the feed system to send the proper amount of pellets needed to maintain the

desired set temperature.

 If your cooker seems slow to start, not starting at all, or producing a lot of smoke

upon start up clean the fire pot and try again.

Assembly Instructions

 Locate shelf from the box under the grill and use a 7/16 wrench to install on

the right end of the grill using the bolts supplied.

Fast Eddy's Model PG500