GABOR ACCUGEAR UPMP-1000 Benutzerhandbuch - Seite 7
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Racks & Ständer GABOR ACCUGEAR UPMP-1000 herunter. GABOR ACCUGEAR UPMP-1000 16 Seiten. Universal projector mount
Seite drucken
Concrete
Warning! Make sure the concrete anchors are installed into solid concrete that is
at least 8 inches (20 cm) thick. If concrete exhibits cracks or other defects, this
may result in failure of the concrete anchors and cause serious personal injury or
equipment damage.
1. Place the mounting plate at the location marked for your projector, and mark
the spot of the two mounting plate holes for drilling.
2. Use a 5/16-inch (8 mm) concrete drill bit to make
holes 2.5-inches (64 mm) deep on the marked
spots, and then clean out debris.
3. Insert the concrete anchors flush to the concrete, and use a mallet to
hammer the anchors into the drilled holes.
4. Attach the plate by inserting the anchor screws through the washers and
mounting plate holes, and screwing them into the concrete anchors until
secure.
5. Use a 3/8 inch (10 mm) crescent wrench
to tighten the anchor screws through
the plate's access slots.
C
A
F
D
2.5 in.
2.5 in.
C
F
D
7