GABOR ACCUGEAR UPMP-1000 사용자 설명서 - 페이지 7

{카테고리_이름} GABOR ACCUGEAR UPMP-1000에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. GABOR ACCUGEAR UPMP-1000 16 페이지. Universal projector mount

Concrete

Warning! Make sure the concrete anchors are installed into solid concrete that is

at least 8 inches (20 cm) thick. If concrete exhibits cracks or other defects, this

may result in failure of the concrete anchors and cause serious personal injury or

equipment damage.

1. Place the mounting plate at the location marked for your projector, and mark

the spot of the two mounting plate holes for drilling.

2. Use a 5/16-inch (8 mm) concrete drill bit to make

holes 2.5-inches (64 mm) deep on the marked

spots, and then clean out debris.

3. Insert the concrete anchors flush to the concrete, and use a mallet to

hammer the anchors into the drilled holes.

4. Attach the plate by inserting the anchor screws through the washers and

mounting plate holes, and screwing them into the concrete anchors until

secure.

5. Use a 3/8 inch (10 mm) crescent wrench

to tighten the anchor screws through

the plate's access slots.

2.5 in.