GABOR ACCUGEAR UPMP-1000 사용자 설명서 - 페이지 6

{카테고리_이름} GABOR ACCUGEAR UPMP-1000에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. GABOR ACCUGEAR UPMP-1000 16 페이지. Universal projector mount

Wood Studs

Wood studs run vertically inside the wall or across the ceiling, behind the drywall

or plaster. The plate must be mounted to a wood stud, or the plate could fall out

and damage the projector or cause personal harm.

Make sure the studs are at least 1.5 inches (38 mm) wide.

1. Use a stud finder to locate the edges of the wooden

stud.

2. Mark the centerline of the stud.

3. Place the mounting plate at the location marked for

your projector, and mark the spot of the two

mounting plate holes for drilling. Make sure this is

on the center line of the stud.

4. Use a 5/32-inch (4 mm) wood drill bit to predrill the

two marked spots for support holes 2.5 inches (64

mm) deep, and then clean out the debris.

5. Attach the plate by inserting the anchor screws

through the washers and mounting plate holes and

screwing them into the predrilled support holes

until secure.

6. Use a 3/8 inch (10 mm)

crescent wrench

to tighten the

anchor screws

through the

plate's access

slots.

1.5 in.

Drywall

2.5 in.