GABOR ACCUGEAR UPMP-1000 Руководство пользователя - Страница 6
Просмотреть онлайн или скачать pdf Руководство пользователя для Стойки и подставки GABOR ACCUGEAR UPMP-1000. GABOR ACCUGEAR UPMP-1000 16 страниц. Universal projector mount
Wood Studs
Wood studs run vertically inside the wall or across the ceiling, behind the drywall
or plaster. The plate must be mounted to a wood stud, or the plate could fall out
and damage the projector or cause personal harm.
Make sure the studs are at least 1.5 inches (38 mm) wide.
1. Use a stud finder to locate the edges of the wooden
stud.
2. Mark the centerline of the stud.
3. Place the mounting plate at the location marked for
your projector, and mark the spot of the two
mounting plate holes for drilling. Make sure this is
on the center line of the stud.
4. Use a 5/32-inch (4 mm) wood drill bit to predrill the
two marked spots for support holes 2.5 inches (64
mm) deep, and then clean out the debris.
5. Attach the plate by inserting the anchor screws
through the washers and mounting plate holes and
screwing them into the predrilled support holes
until secure.
6. Use a 3/8 inch (10 mm)
crescent wrench
to tighten the
anchor screws
through the
plate's access
slots.
6
A
F
D
1.5 in.
Drywall
X
2.5 in.
F
D