GABOR Levitouch DM-550 Benutzerhandbuch - Seite 7

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Racks & Ständer GABOR Levitouch DM-550 herunter. GABOR Levitouch DM-550 17 Seiten. Single arm monitor mount for 17 to 32 in. desktop computer monitors

Seite drucken

Clamp Installation

Attach the flange (E) to the base (F) with

the three hex screws (J). Tighten them with

hex key (N) until secure.

Fit the flange behind the desk. You may

need to remove the flange bolts if the space

between the desk and wall is too tight.

Before you attach the clamp to the flange,

measure the thickness of the table or

desktop.

•

If the desktop is 0.4 to 2 inches thick, screw

the flange bolts into the top holes.

•

If the desktop is 2 to 3.3 inches thick,

remove the flange bolts from the top holes,

and screw them into the bottom holes.

To attach the clamp to the flange, fit the

wide end of the clamp holes over the flange

bolts, and press down on the clamp so it

securely sits on the flange bolts.

Important! The clamp should rest on the ﬂange

bolts. If the clamp is not parallel to the bottom

of the base, loosen the ﬂange bolts until the

clamp rests entirely on them.

Tighten the flange bolts with hex key (N)

until secure.

With the flange flush against the edge of

the desktop, tighten the clamp locking knob

until the base is secured to the desktop.