GABOR Levitouch DM-550 Manual del usuario - Página 7
Navegue en línea o descargue pdf Manual del usuario para Bastidores y soportes GABOR Levitouch DM-550. GABOR Levitouch DM-550 17 páginas. Single arm monitor mount for 17 to 32 in. desktop computer monitors
Imprimir página
Clamp Installation
1.
Attach the flange (E) to the base (F) with
the three hex screws (J). Tighten them with
hex key (N) until secure.
E
J
2.
Fit the flange behind the desk. You may
need to remove the flange bolts if the space
between the desk and wall is too tight.
3
D
3.
Before you attach the clamp to the flange,
measure the thickness of the table or
desktop.
F
•
If the desktop is 0.4 to 2 inches thick, screw
the flange bolts into the top holes.
•
If the desktop is 2 to 3.3 inches thick,
remove the flange bolts from the top holes,
and screw them into the bottom holes.
N
To attach the clamp to the flange, fit the
wide end of the clamp holes over the flange
bolts, and press down on the clamp so it
securely sits on the flange bolts.
4
N
Important! The clamp should rest on the flange
bolts. If the clamp is not parallel to the bottom
of the base, loosen the flange bolts until the
clamp rests entirely on them.
4.
Tighten the flange bolts with hex key (N)
until secure.
5.
With the flange flush against the edge of
the desktop, tighten the clamp locking knob
until the base is secured to the desktop.
5
D
E
F
J
N
1X
1X
1X
3X
1X
7