GABOR Levitouch DM-552 Benutzerhandbuch - Seite 8

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Racks & Ständer GABOR Levitouch DM-552 herunter. GABOR Levitouch DM-552 17 Seiten. Dual arm monitor mount for 17 to 32 in. desktop computer monitors

Seite drucken

Grommet (Non-edge) Installation

Important! Predrilled holes in the desktop should be between of 0.4 to 2.4 inches (10 to 60 mm)

in diameter.

If you need to drill a hole in

the desktop, use a 3/8-inch

or 10 mm drill bit.

Attach the notch cover (G)

to the bottom of the base

with the flat hex screws (J).

Make sure the flat side of

the cover is even with the

edge of the base.

Place the base on the desktop, and insert the

carriage bolt (I) through the top of the base

socket and the hole in the desktop. Once it's

inserted, make sure the bolt head sits flush

against the base's hole.

Beneath the desktop, slide the clamping

flange (H) onto the carriage bolt (I), and then

slide the washer (K) onto the carriage bolt.

Screw the hex nut (L) onto the bolt. Tighten it

by hand, and then use the wrench (P) to fully

tighten the clamping flange to the desktop.

Place the plastic cap (M) into the grommet

hole to cover the carriage bolt.