GABOR Levitouch DM-552 Kullanıcı Kılavuzu - Sayfa 8
Raflar ve Standlar GABOR Levitouch DM-552 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. GABOR Levitouch DM-552 17 sayfaları. Dual arm monitor mount for 17 to 32 in. desktop computer monitors
Sayfayı Yazdır
Grommet (Non-edge) Installation
Important! Predrilled holes in the desktop should be between of 0.4 to 2.4 inches (10 to 60 mm)
in diameter.
1.
If you need to drill a hole in
the desktop, use a 3/8-inch
or 10 mm drill bit.
2.
Attach the notch cover (G)
to the bottom of the base
with the flat hex screws (J).
Make sure the flat side of
the cover is even with the
edge of the base.
8
1
F
G
J
N
3.
Place the base on the desktop, and insert the
carriage bolt (I) through the top of the base
socket and the hole in the desktop. Once it's
inserted, make sure the bolt head sits flush
against the base's hole.
4.
Beneath the desktop, slide the clamping
flange (H) onto the carriage bolt (I), and then
slide the washer (K) onto the carriage bolt.
5.
Screw the hex nut (L) onto the bolt. Tighten it
by hand, and then use the wrench (P) to fully
tighten the clamping flange to the desktop.
6.
Place the plastic cap (M) into the grommet
hole to cover the carriage bolt.
F
G
H
I
J
K
L
M
N
1X
1X
1X
1X
3X
1X
1X
1X
1X
M
I
K
L
P
P
1X
H