Benedini TBS Mini Handbuch Technische Daten - Seite 5
Blättern Sie online oder laden Sie pdf Handbuch Technische Daten für Aufnahmegeräte Benedini TBS Mini herunter. Benedini TBS Mini 11 Seiten. Digital multifunctional rc-soundunit
Auch für Benedini TBS Mini: Handbuch (11 seiten), Handbuch (11 seiten)
Seite drucken
3. Control modes
There are several control modes possible, using various TX switch functions and the appropriate
Prop'X' control inputs, with the TBS Mini Sound Unit also set to interpret the signals correctly.
-
Encoder. Using a 12 position encoder, or multi-switch panel.
-
Direct Sound Selection. This has two methods possible.
One uses a 3Pos TX switch signal into Prop2 allowing just two of the additional sounds to
be played.
One uses a 3Pos TX switch signal into Prop3 and allows all additional sounds to be played.
-
Indirect Sound Selection
-
Autostart. This mode only uses the Throttle signal to control startup, running, and shutdown
of the engine sound only. No additional sounds can be controlled or played.
The supplied control mode that was set in the Sound Unit at delivery is indicated on the first page of
this manual.
Please refer to the appropriate section below on how to teach the sound unit your control method.
3.1. Controlling the sound unit by the 12-positon "encoder" (12-Key coder)
The most comfortable way of controlling the sound unit is using the so called "12-position
encoder". It consists of a 12 position rotary switch in combination with a push button. The desired
sound is selected by the rotary switch position and is then triggered by the push button.
The encoder is connected into your transmitter to a spare proportional channel. This TX mod must
be done by yourself. The rotary switch is optional and must be ordered separately!
After installation you should test the encoder by using a servo on the appropriate receiver channel
you intend to use. Keep the encoder push button pressed and move the rotary switch through all
positions. The servo should move to a new position at each rotary switch position. The total
movement of the servo should be about the same as at a normal joystick channels set to 100%
travel.
Rotary switch for sound selection
Trigger switch
Connect to a spare
proportional Channel
of your TX.
The installation of the encoder in your transmitter is on your own risk
Proper functionality is not guaranteed at ALL transmitter brands / types
TBS Mini
The total resistance of the encoder can be adjusted
to your TX by two solder bridges at the rear side
of the encoder pcb:
BOTH bridges - Total resistance
open
closed
www.benedini.de
approx. 22 KOhm
approx.
5 KOhm
Page 5 of 11