GREAT PLAINS 1205NT Handbuch vor der Auslieferung - Seite 14
Blättern Sie online oder laden Sie pdf Handbuch vor der Auslieferung für Landwirtschaftliche Geräte GREAT PLAINS 1205NT herunter. GREAT PLAINS 1205NT 20 Seiten. End wheel no-till drill
Auch für GREAT PLAINS 1205NT: Handbuch für die Feldanpassung (5 seiten)
Seite drucken12
1205NT
Setup
Hitching Tractor to Drill
!
DANGER
You may be severely injured or killed by being crushed
between the tractor and drill. Do not stand or place
any part of your body between drill and moving trac-
tor. Stop tractor engine and set park brake before in-
stalling the hitch pin.
Hitch Assembly
1. See Figure 5.
clevis hitch (2) with a spacer tube (3) on each
side of ball swivel.
2. Bolt in place with 1 x 5 1/2 inch bolt (4), flat
washer (5) and nylock nut (6).
Hitch Height
1. For proper field operation, drill tongue should
run level in field position. See Figure 6.
a. With drill in field position, adjust tongue
jack to level tongue.
b. Measure tractor drawbar height to deter-
mine proper hitch height on drill.
c. Attach hitch to tongue with two 3/4 x 6
inch bolts (1), lock washers (2) and nuts
(3).
NOTE: Mounting holes in drill hitch are offset so
hitch can be turned over and attached in three dif-
ferent positions, giving six different hitch heights.
NOTE: When hitching drill to a different tractor,
check for a difference in drawbar heights. If
heights are different, readjust accordingly.
150-131Q
Insert upper hitch plate (1) into
Figure 5
Hitch Assembly
Figure 6
Hitch Height
13939
13940
3/24/06