- ページ 14

農機具 GREAT PLAINS 1205NTのPDF プレデリバリーマニュアルをオンラインで閲覧またはダウンロードできます。GREAT PLAINS 1205NT 20 ページ。 End wheel no-till drill
GREAT PLAINS 1205NT にも：フィールド調整マニュアル (5 ページ)

ページを印刷する

1205NT

Setup

Hitching Tractor to Drill

DANGER

You may be severely injured or killed by being crushed

between the tractor and drill. Do not stand or place

any part of your body between drill and moving trac-

tor. Stop tractor engine and set park brake before in-

stalling the hitch pin.

Hitch Assembly

1. See Figure 5.

clevis hitch (2) with a spacer tube (3) on each

side of ball swivel.

2. Bolt in place with 1 x 5 1/2 inch bolt (4), ﬂat

washer (5) and nylock nut (6).

Hitch Height

1. For proper ﬁeld operation, drill tongue should

run level in ﬁeld position. See Figure 6.

a. With drill in ﬁeld position, adjust tongue

jack to level tongue.

b. Measure tractor drawbar height to deter-

mine proper hitch height on drill.

c. Attach hitch to tongue with two 3/4 x 6

inch bolts (1), lock washers (2) and nuts

(3).

NOTE: Mounting holes in drill hitch are offset so

hitch can be turned over and attached in three dif-

ferent positions, giving six different hitch heights.

NOTE: When hitching drill to a different tractor,

check for a difference in drawbar heights. If

heights are different, readjust accordingly.

150-131Q

Insert upper hitch plate (1) into

Figure 5

Hitch Assembly

Figure 6

Hitch Height

13939

13940

3/24/06