ADEMCO TI110B1 Benutzerhandbuch - Seite 17

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Sicherheitssystem ADEMCO TI110B1 herunter. ADEMCO TI110B1 18 Seiten. Gsm/pstn dual network burglar alarm system

Seite drucken

Dimension: 190×190×50mm (without antenna)

Ⅶ.Cautions:

1. Before the program task, please turn the "Program" switch to the "on" position for

programming or checking operation. And after the operation task is completed, make sure the

"Program" switch is turn off ; otherwise, the host cannot work normally or subject to the

disorder or deleting operation

2. On programming the every item, please press the "

3. The host is available for telephone network with DTMF dialing and GSM network

4. There are "high-volume" and "mute" switches available in the host. Please make sure that the

switch status is in accordance with your requirement, avoiding no alarm when the host

triggers the alarm.

5. Periodic test/examination for fault-elimination

6. Pay attention to checking whether the indicator light of wireless infrared detectors shine

normally or not. If not, please change the battery to ensure its normal work.

7. After triggering the alarm and no "reset "operation, the host will automatically stop alarm 10

minutes later.

8. With limited capacity, the backup battery is for the emergency. And the host should be

supplied by power AC mainly.

9. The remote control is forbidden being drop heavily or being soaked. The battery for the

remote control should be changed timely to ensure its normal work once its controlling

distance become shorter

10. The company is responsible for two years' warranty of the products.

11. Please read the Special Cautions carefully

Ⅷ.Fault Elimination

Here we offer you some possible causes and solution for your consideration when the

alarm system cannot work normally or suffer from the operational failure. Please refer

to the following chart

Troubles

GSM SIM card isn't placed well

GSM signal failure

GSM fails to dial

the numbers

Program cell phone fails to log in the

alarm panel

Reset

Possible Reasons

" button

Solutions

Place the GSM SIM card into

the right position

Try to put the alarm panel to

check whether the GSM signal

shines or not. Note: Constant

shining means the signal is ok

(GSM SIM) Activate the caller

display function and cancel the

CRBT and then re-log in the

alarm panel