ADEMCO TI110B1 Посібник користувача - Сторінка 17
Переглянути онлайн або завантажити pdf Посібник користувача для Система безпеки ADEMCO TI110B1. ADEMCO TI110B1 18 сторінок. Gsm/pstn dual network burglar alarm system
Друкувати сторінкуDimension: 190×190×50mm (without antenna)
Ⅶ.Cautions:
1. Before the program task, please turn the "Program" switch to the "on" position for
programming or checking operation. And after the operation task is completed, make sure the
"Program" switch is turn off ; otherwise, the host cannot work normally or subject to the
disorder or deleting operation
2. On programming the every item, please press the "
3. The host is available for telephone network with DTMF dialing and GSM network
4. There are "high-volume" and "mute" switches available in the host. Please make sure that the
switch status is in accordance with your requirement, avoiding no alarm when the host
triggers the alarm.
5. Periodic test/examination for fault-elimination
6. Pay attention to checking whether the indicator light of wireless infrared detectors shine
normally or not. If not, please change the battery to ensure its normal work.
7. After triggering the alarm and no "reset "operation, the host will automatically stop alarm 10
minutes later.
8. With limited capacity, the backup battery is for the emergency. And the host should be
supplied by power AC mainly.
9. The remote control is forbidden being drop heavily or being soaked. The battery for the
remote control should be changed timely to ensure its normal work once its controlling
distance become shorter
10. The company is responsible for two years' warranty of the products.
11. Please read the Special Cautions carefully
Ⅷ.Fault Elimination
Here we offer you some possible causes and solution for your consideration when the
alarm system cannot work normally or suffer from the operational failure. Please refer
to the following chart
Troubles
GSM SIM card isn't placed well
GSM signal failure
GSM fails to dial
the numbers
Program cell phone fails to log in the
alarm panel
Reset
Possible Reasons
17
" button
Solutions
Place the GSM SIM card into
the right position
Try to put the alarm panel to
check whether the GSM signal
shines or not. Note: Constant
shining means the signal is ok
(GSM SIM) Activate the caller
display function and cancel the
CRBT and then re-log in the
alarm panel