AFG 1.0AT Benutzerhandbuch - Seite 6

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Laufband AFG 1.0AT herunter. AFG 1.0AT 17 Seiten. Afg series

AFG 1.0AT Benutzerhandbuch
AS SE MB LY ST EP
HARDWARE BAG CONTENTS :
LEFT CONSOLE MAST
A
Open HARDWARE BAG .
B
With running deck in lowered position, place CONSOLE on upright masts. Align the
brackets that are underneath the console with the holes of the upright masts.
C
To assemble the LEFT CONSOLE MAST to the CONSOLE, insert 1 BOLT (G) into the hole in
the LEFT CONSOLE MAST and lightly tighten.
D
Gently lift RIGHT side of the CONSOLE to connect the CONSOLE CABLE. Carefully tuck wires
in mast to avoid damage. NOTE: Do not pinch console cable wires.
E
Repeat STEP C above to attach the RIGHT CONSOLE MAST to the CONSOLE.
F
Tighten console bolts completely.
G
Fit PLUGS (H) over each BOLT (G) head after tightening.
10
1.0AT_Rev.1.2.indd 10-11
BOLT (G)
PLUGS (H)
50 mm
Qty: 2
Qty: 2
PLUGS (H)
BOLTS (G)
CONSOLE
* NOTE: Be
careful not to
DO NOT ATTACH
pinch any
THIS SIDE UNTIL STEP 3-D
wires while
CONSOLE CABLE
attaching the
console.
RIGHT CONSOLE MAST
ASSEMBLY STEP
HARDWARE BAG CONTENTS :
BOLT (I)
90 mm
Qty: 2
BOLT (I)
ARC WASHER (J)
A
Open HARDWARE BAG .
B
Align SUPPORT BAR with holes in CONSOLE MASTS.
C
Insert BOLTS (I) and ARC WASHERS (J) into holes of the SUPPORT BAR.
NOTE: Look into holes in the right mast before inserting bolts to avoid pinching cables.
D
Tighten support bar bolts completely.
POWER SWITCH
CIRCUIT BREAKER
YOU'RE FINISHED!
ARC WASHER (J)
17 mm
Qty: 2
CONSOLE
BOLT (I)
ARC WASHER (J)
SUPPORT BAR
CONSOLE MASTS
Connect power plug to the treadmill
and connect the cord to a power
outlet. The on/off switch is located
next to the power cord. Flip this
switch to the 'ON' position, so that
the switch is lit. You will hear a
beep and the console will light up.
11
7/23/07 10:47:14 AM