GREAT PLANES Riot 3D Gebrauchsanweisung - Seite 12

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Spielzeug GREAT PLANES Riot 3D herunter. GREAT PLANES Riot 3D 20 Seiten.

❏

3. Attach the ESC to the inside wall of the fuselage as

shown using hook and loop material or double-sided tape.

❏

4. Connect the motor leads to the ESC. Check for the proper

direction of rotation. If the motor operates in the wrong

direction, disconnect and swap any TWO motor leads.

Battery & Receiver Installation

❏

1. Connect all servo leads and the ESC at this time. Attach

the receiver to the inside of the fuselage behind the main wing

using hook and loop material or double-sided tape as shown.

❏

2. Place a small length of the "hook" (rough) side of hook

and loop material on the inside of the fuselage near the nose

of the aircraft as shown. The "loop" (soft) side of the hook and

loop material is attached to the battery. Do not connect the

battery to the ESC until ready to fly.

❏

3. Drill two 1/16" [1.6mm] holes approximately 1/4" [6.4mm]

apart. Route the antenna from the receiver out of the bottom of

the airplane and "thread" it into the tail skid as shown.

❏

1. Insert the pre-bent landing gear wire into the slot in

the fuselage. Locate the small gear retainer block and

press it into the slot with your thumb after the pre-bent

landing gear wire is in place as shown. Glue the block into

place with thin CA.

❏

2. Trim the wheel pants along the cut lines to match the

shape above.