GREAT PLANES Riot 3D Gebrauchsanweisung - Seite 14

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Spielzeug GREAT PLANES Riot 3D herunter. GREAT PLANES Riot 3D 20 Seiten.

Seite drucken

❏

3. Make certain that the control surfaces and motor

respond in the correct direction as shown in the diagram. If

any of the controls respond in the wrong direction, use the

servo reversing in the transmitter to reverse the servos

connected to those controls. Be certain the control surfaces

have remained centered. Adjust if necessary.

Set the Control Throws

Due to the size of the Riot 3D ARF and its control surfaces,

we recommend the use of a ruler to accurately measure and

set the control throw of each control surface as indicated in

the chart that follows. If your radio does not have dual rates,

we recommend setting the throws at the high rate setting

(not at the 3D rates).

Note: The throws are measured at the widest part of the

elevators, rudder and ailerons.

These are the recommended control surface throws:

High Rate

ELEVATOR:

1/2" [13mm] up

1/2" [32mm] down

RUDDER:

1-3/8" [35mm] right 1" [25mm] right

1-3/8" [35mm] left

AILERONS:

5/8" [16mm] up

5/8" [16mm] down

3D ELEVATOR:

3D RUDDER:

3D AILERONS:

IMPORTANT: The Riot 3D ARF has been extensively

flown and tested to arrive at the throws at which it flies

best. Flying your model at these throws will provide you

with the greatest chance for successful first flights. If, after

you have become accustomed to the way the Riot 3D ARF

flies, you would like to change the throws to suit your

taste, that is fine. However, too much control throw could

make the model difficult to control, so remember, "more is

not always better."

Balance the Model (C.G.)

More than any other factor, the C.G. (balance point) can

have the greatest effect on how a model flies, and may

determine whether or not your first flight will be

successful. If you value this model and wish to enjoy it for

many flights, DO NOT OVERLOOK THIS IMPORTANT

PROCEDURE. A model that is not properly balanced will

be unstable and possibly unflyable.

At this stage the model should be in ready-to-fly condition

with all of the systems in place including the motor, battery,

and the radio system.

Low Rate

3/8" [9.5mm] up

3/8" [9.5mm] down

1" [25mm] left

3/8" [9.5mm] up

3/8" [9.5mm] down

3D RATES

1-3/8" [35mm] up

1-3/8" [35mm] down

2" [51mm] right

2" [51mm] left

2" [51mm] up

2" [51mm] down