Great White GW9500 Benutzerhandbuch - Seite 3
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Schwimmbad-Staubsauger Great White GW9500 herunter. Great White GW9500 12 Seiten. Automatic pool cleaner
Seite druckenPlease use the convenient, water resistant, "EASY-STEPS" card.
Figure 1
Handle
Hose
4'
8'
20'
1902 0795
Figure 2
Figure 3
Swivel
Assembly
Figure 5
Figure 7
ABOUT INSTALLATION
1882 0795
Cleaner
Reducer
Cone
Hose
Swivel
Adapter
Ass'y
Short Hose (4")
Vacuum
Regulator
w/2 Caps
Skimmer
Vac
Port
1880 07
Figure 4
Figure 6
Hose Cuff
marked
"Connect
to Cleaner"
1875 0795
Step 1: Straighten hose (Figure 1)
Remove and uncoil the hose from the carton. Lay it out
in the sunlight, flat and straight.
Step 2: Check parts (Figure 2)
• Cleaner assembly
• Black plastic swivel assembly
• Handle adapter
• White rubber reducer cone
• Hoses: 20', 8', 4' and 4"
• White plastic vacuum regulator
• Extra cap for regulator marked "50"
• Vacuum port fitting
• Male to male hose adapter
Step 3: Clean filter system (Figure 3)
Backwash and clean filter; rinse; clean all baskets, etc.
Start pump.
Step 4: Adjust valves for vacuuming (Figure 4)
Decide on the vacuum connection you are going to use
(either a skimmer or a dedicated wall fitting) and adjust
the pump valves (if your system has valves) to direct all
vacuum there.
Close the main drain (also see "About Fine Tuning the
Vacuum", Page 4)
Step 5: Assemble cleaner (Figure 5)
Insert swivel assembly into cleaner; twist 1/4 turn.
Step 6: Measure hose length needed (Figure 6)
Before connecting the hose, lay it out from the vacuum
connection you are using (whether skimmer or dedicat-
ed wall fitting) to the furthest point of the pool. The
hose should be at least 4' longer than this. More than 4'
longer is OK. Do not cut the hose.
Step 7: Connect hose to cleaner (Figure 7)
Connect the 20' hose end marked "connect to cleaner"
to the black swivel assembly. Connect the white plastic
vacuum regulator to the opposite end of the hose.
Step 8: Connect hose to filter system (Figure 8)
Fill the cleaner and hose with water and connect to the
suction source. The cleaner will begin to operate.
Figure 8
3