Great White GW9500 소유자 매뉴얼 - 페이지 3

{카테고리_이름} Great White GW9500에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Great White GW9500 12 페이지. Automatic pool cleaner

페이지 인쇄

Please use the convenient, water resistant, "EASY-STEPS" card.

Figure 1

Handle

Hose

20'

1902 0795

Figure 2

Figure 3

Swivel

Assembly

Figure 5

Figure 7

ABOUT INSTALLATION

1882 0795

Cleaner

Reducer

Cone

Hose

Swivel

Adapter

Ass'y

Short Hose (4")

Vacuum

Regulator

w/2 Caps

Skimmer

Vac

Port

1880 07

Figure 4

Figure 6

Hose Cuff

marked

"Connect

to Cleaner"

1875 0795

Step 1: Straighten hose (Figure 1)

Remove and uncoil the hose from the carton. Lay it out

in the sunlight, flat and straight.

Step 2: Check parts (Figure 2)

• Cleaner assembly

• Black plastic swivel assembly

• Handle adapter

• White rubber reducer cone

• Hoses: 20', 8', 4' and 4"

• White plastic vacuum regulator

• Extra cap for regulator marked "50"

• Vacuum port fitting

• Male to male hose adapter

Step 3: Clean filter system (Figure 3)

Backwash and clean filter; rinse; clean all baskets, etc.

Start pump.

Step 4: Adjust valves for vacuuming (Figure 4)

Decide on the vacuum connection you are going to use

(either a skimmer or a dedicated wall fitting) and adjust

the pump valves (if your system has valves) to direct all

vacuum there.

Close the main drain (also see "About Fine Tuning the

Vacuum", Page 4)

Step 5: Assemble cleaner (Figure 5)

Insert swivel assembly into cleaner; twist 1/4 turn.

Step 6: Measure hose length needed (Figure 6)

Before connecting the hose, lay it out from the vacuum

connection you are using (whether skimmer or dedicat-

ed wall fitting) to the furthest point of the pool. The

hose should be at least 4' longer than this. More than 4'

longer is OK. Do not cut the hose.

Step 7: Connect hose to cleaner (Figure 7)

Connect the 20' hose end marked "connect to cleaner"

to the black swivel assembly. Connect the white plastic

vacuum regulator to the opposite end of the hose.

Step 8: Connect hose to filter system (Figure 8)

Fill the cleaner and hose with water and connect to the

suction source. The cleaner will begin to operate.

Figure 8