Daytona 87352 Gebrauchsanweisung - Seite 3

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Zubehör für Motorräder Daytona 87352 herunter. Daytona 87352 8 Seiten. Smartphone controller

Seite drucken

Package Contents

・Remote controller x1

Part Name

Enter button

Escape button

Clamp

Home button

––

Using the Smartphone Controller

1. Installing batteries

Remove the battery case lid on the side panel of the Smartphone Controller using a coin, insert the button batteries included in the

package into the battery case, and then replace the lid.

CAUTION

* Insert the button batteries in the correct orientation by paying attention to the polarity of the batteries.

* Attach the water-resistant O-ring carefully before you replace the lid. If the position of the O-ring is slightly off, water-resistant

performance will decline and water might enter the unit.

* The rotatable angle of the battery case lid is about 5 degrees. Do not use force to rotate it further.

Otherwise, the lid will be damaged.

* Supplied batteries have been used to check the operation at the

time of shipment from the factory.

Therefore, the life of the original batteries may be short.

Daytona Corp. recommends that you replace the batteries

before you start using the Smartphone Controller.

2. Installing the Smartphone Controller on your vehicle

・Remove the clamp fixing screws to remove the clamp from the Smartphone Controller body, and then install the clamp and

Smartphone Controller body in a location on the handlebar or grip that will not interfere with your driving.

Use the supplied spacers or rubber spacers, depending on the thickness of the handlebar or grip. The inner diameter of the

Smartphone Controller is approximately φ38mm without any spacers. The diameter will become φ31mm if the spacers are attached.

If the diameter of the handlebar is φ25.4mm or φ22.2mm, attach the rubber spacers to the inner side of the spacers.

CAUTION

* Do not insert the clamp fixing screws on a slant, and do not tighten them too much. Otherwise, the screw holes on the Smartphone

Controller and the clamp fixing screws will be damaged. Tighten the screws carefully.

––

Clamp

fixing

screw

・Clamp x1

Power button

Clamp

・Rubber spacer

・Spacer x2

(Long) (Short) x2 each

Battery

case lid

LED

indicator

Cross joystick

Open

Spacer

・Clamp fixing screw x2

O-ring

Button

battery

Clamp fixing

screw

Spacer

* If the diameter of the handlebar is

φ25.4mm or φ22.2mm, attach the

rubber spacers to the inner side of the

spacers.

87352③/⑧

＋

－

Rubber spacer

December 17, 2014