Daytona 87352 Manual de instruções - Página 3
Procurar online ou descarregar pdf Manual de instruções para Acessórios para motociclos Daytona 87352. Daytona 87352 8 páginas. Smartphone controller
Imprimir páginaPackage Contents
・Remote controller x1
Part Name
Enter button
Escape button
Clamp
Home button
––
Using the Smartphone Controller
1. Installing batteries
Remove the battery case lid on the side panel of the Smartphone Controller using a coin, insert the button batteries included in the
package into the battery case, and then replace the lid.
CAUTION
* Insert the button batteries in the correct orientation by paying attention to the polarity of the batteries.
* Attach the water-resistant O-ring carefully before you replace the lid. If the position of the O-ring is slightly off, water-resistant
performance will decline and water might enter the unit.
* The rotatable angle of the battery case lid is about 5 degrees. Do not use force to rotate it further.
Otherwise, the lid will be damaged.
* Supplied batteries have been used to check the operation at the
time of shipment from the factory.
Therefore, the life of the original batteries may be short.
Daytona Corp. recommends that you replace the batteries
before you start using the Smartphone Controller.
2. Installing the Smartphone Controller on your vehicle
・Remove the clamp fixing screws to remove the clamp from the Smartphone Controller body, and then install the clamp and
Smartphone Controller body in a location on the handlebar or grip that will not interfere with your driving.
Use the supplied spacers or rubber spacers, depending on the thickness of the handlebar or grip. The inner diameter of the
Smartphone Controller is approximately φ38mm without any spacers. The diameter will become φ31mm if the spacers are attached.
If the diameter of the handlebar is φ25.4mm or φ22.2mm, attach the rubber spacers to the inner side of the spacers.
CAUTION
* Do not insert the clamp fixing screws on a slant, and do not tighten them too much. Otherwise, the screw holes on the Smartphone
Controller and the clamp fixing screws will be damaged. Tighten the screws carefully.
––
Clamp
fixing
screw
・Clamp x1
Power button
Clamp
・Rubber spacer
・Spacer x2
(Long) (Short) x2 each
Battery
case lid
LED
indicator
Cross joystick
Open
Spacer
・Clamp fixing screw x2
O-ring
Button
battery
Clamp fixing
screw
Close
Spacer
* If the diameter of the handlebar is
φ25.4mm or φ22.2mm, attach the
rubber spacers to the inner side of the
spacers.
87352③/⑧
＋
－
Rubber spacer
December 17, 2014